Hi, could you please run the following command twice and share the output of both runs? mserver5 --dbpath=/tmp/MyDBfarm/MyDB
Dear Admin, I am running Ubuntu linux 14.04 LTS, x86_64-Ubuntu-linux-gnu/64bit with 128bit integers. i recently installed MonetDB5 default branch from the mercurial repository.
I tried to rebuild and enable geom module but to no avail, it shows no error, after compilation it shows that the module is enabled,However when i run the mserver the monetDB/GIS module is not loaded as expected. I am stuck and i don't seem to know how to proceed forward in order to run my spatial queries
Are there any setting i need to do explicitly to load this module?
the command i used: ./configure --prefix=/home/joweria/MonetDB-Nov2016-SP4 --enable-geom=yes --enable-pyintegration=yes --with-geos=yes
and then after compilation under the LDFLAGS-enabled componets geom is one of the enabled componet but when i run the mserver5 the module is not loaded as expected.
I rebuild monetDB again and for first time i run the mserver5 commans and the GIS module was successfully loaded ie (MonetDB/SQL/GIS module is loaded) but when i closed the session (\q) and ran the same command again the module was not loaded. i tried exporting paths to no avail. what could be the problem? please i need your kind help.
Thank you
Regards, Joweria nakibuuka
_______________________________________________ developers-list mailing list developers-list@monetdb.org https://www.monetdb.org/mailman/listinfo/developers-list
-- | Stefan.Manegold@CWI.nl | DB Architectures (DA) | | www.CWI.nl/~manegold/ | Science Park 123 (L321) | | +31 (0)20 592-4212 | 1098 XG Amsterdam (NL) |